PCS – Pulseworx – UPB – ELK M1 UPB Products, universal powerline bus, elk-m1pcspim, simply automated UMC-USB lower pricing, better value and support.
 |
 |
PCS – Pulseworx
UPB Powerline Control
UPB Interface for M1G & M1EZ8 Controls
ELK-M1PCSPIM
The ELK-M1PCSPIM is a special UPB Powerline Interface Module containing a built-in M1XSP Serial Port chip. UPB phase coupler, UPB PIM UPB UPStart, Home automation, lighting control, Simply Automated UPB, leading home automation and lighting control. This all-in-one device makes it easy to permanently connect the ELK M1 Control to a UPB network. Simply locate a convenient unused AC Power Outlet, connect a cable from the M1 data bus to the four (4) terminals on the ELKM1 PCSPIM, and perform an M1 data bus enrollment. The long distance capability of the M1 data bus makes it possible to locate the ELKM1 PCSPIM virtually anywhere, without a lot of complex or ugly cabling or connections. UPB utilizes the AC wiring circuit for transmission, without new or additional wiring, and without radio frequency signals.
Features:
• All-in-one device for interfacing M1 with UPB.
• Compact interface requires small amount of space
• Easy hookup — requires only the 4-wire data bus connection. * NO 9-Pin Serial Cable *
• Includes UPB Status light (multicolored) AND a M1 Data Bus Status Light (Green) — enhances the ability to diagnose and troubleshoot
• Lower cost than purchasing separate and M1XSP and PCSPIM products.
• Removable 4-pin terminal block connection
• Compact interface requires small amount of space
• Easy hookup — requires only the 4-wire data bus connection. * NO 9-Pin Serial Cable *
• Includes UPB Status light (multicolored) AND a M1 Data Bus Status Light (Green) — enhances the ability to diagnose and troubleshoot
• Lower cost than purchasing separate and M1XSP and PCSPIM products.
• Removable 4-pin terminal block connection
Specifications:
• Power:
-UPB Network circuitry – powered from the AC “Primary” Line.
-M1 Data Bus Device circuitry – powered (12VDC) from the M1 Data Bus (+) & (-) terminals.
NOTE: Loss of AC primary power should not result in a missing data bus device trouble.
• Current Draw from M1: ~30mA @ 12 VDC
• M1 Bus Device Address: Preset at Address #7 [Requires bus module enrollment]
• Firmware required: 1.0.42 (std. firmware) or later
-UPB Network circuitry – powered from the AC “Primary” Line.
-M1 Data Bus Device circuitry – powered (12VDC) from the M1 Data Bus (+) & (-) terminals.
NOTE: Loss of AC primary power should not result in a missing data bus device trouble.
• Current Draw from M1: ~30mA @ 12 VDC
• M1 Bus Device Address: Preset at Address #7 [Requires bus module enrollment]
• Firmware required: 1.0.42 (std. firmware) or later
ELK-M1PCSPIM elkm1pcspim UPB interface PIM-E PIM lighting control lighting interface energy managment
ELK Info & News
I’ve used PCS Pulseworx UPB with ELK M1 UPB Products, just want to let you no simply automated UMC-USB is lower priced with better value and support.